qmake error - QT Creator 3.1.1 (opensource)

[ntn7]

@VRonin I've run it via the console and that works.

Tried again via Qt creator and get the same error as before
13:01:47: Running steps for project hello...
13:01:47: Could not start process "C:\Qt\Qt5.3.0\5.3\mingw482_32\bin\qmake.exe" C:\Users\nnathaniel\Downloads\hello\hello\hello.pro -r -spec win32-g++ "CONFIG+=debug"
Error while building/deploying project hello (kit: Desktop)
When executing step 'qmake'
13:01:47: Elapsed time: 00:00.

[J.Hilk]

@ntn7 what kit is selected, when you run it from QtCreator, the auto detected one or the manual one?

[ntn7]

@J-Hilk Hi, below are the kit details that are being used. this is what was setup by default, i haven't changed this.

[jsulm]

@ntn7 You did not answer the question. As you can see there are 2 Kits, so which one do you use?

[ntn7]

@jsulm is this the detail you looking for? :|

if not, please will you point me to the right direction and I'll provide whats needed

[jsulm]

@ntn7 @J-Hilk So, it's the manually added Kit

[J.Hilk]

@jsulm alright
@ntn7

so change it to the auto generated kit, who knows what settings the manual kit has.

on the left hand side in the menu bar the top most icons, there's (above the question mark) the project tab.

select that, enable the auto detection kit, and try compiling and running again

[ntn7]

@jsulm I'm not sure how that was created but after removing it, it works now.
Thank you all for your assistance @VRonin @J-Hilk
Apologies for the extremely basic question :|

[jsulm]

@ntn7 said in qmake error - QT Creator 3.1.1 (opensource):

after removing it

You don't have to remove it, you can easily switch between different Kits

[ntn7]

ok, I really am a little lost now... I've changed the location of the above project and I receive the error again... I've checked the kit thats being used and its only the one referenced above.

what am i doing wrong? :(
am i perhaps building this incorrectly?

[jsulm]

@ntn7 Are the paths to qmake.exe and hello.pro correct?