Helping in calibrating etp-4500ug for working in RPI3

SGaist

Like I wrote before, run it through the debugger. You can install gdb on your Pi.

tictactoe

I install QT5.7 on ubuntu on vmware and cross compile it to the Pi and I can debug my program through it. Do you mean this?

tictactoe

I got what you say . But is a new project for me :-)
I want to solve this problem easier than this.

jsulm

@tictactoe If you really do not want to use a debugger (this is actually something a programmer should learn) you can add qDebug() << "..." to your code at the places where you think the problem occurs. This can help to find out where the crash happens. But it isn't really easier than just using a debugger, which isn't rocket science.

tictactoe

I dont have any problem during on the running of my program . The only problem is the swapping the axes of X,Y of the touch controller.
I want to solve it

tictactoe

finally I cant run ts_calibrate and save calibration point in the /etc/pointercal .
The below list is the last updated of environment variable for tslib and eglfs

export QT_QPA_PLATFORM=eglfs
export QT_QPA_EGLFS_TSLIB=1
export QT_QPA_FB_DISABLE_INPUT=1
export QT_QPA_EGLFS_TOUCHSCREEN_PARAMETERS=/dev/input/event0:invertx=1
export TSLIB_FBDEVICE=/dev/fb0
export TSLIB_CONSOLEDEVICE=/dev/tty
export TSLIB_TSDEVICE=/dev/input/by-id/ls /dev/input/by-id/ | grep "eGalax"
export TSLIB_CONFFILE=/etc/ts.conf
export TSLIB_CALIBFILE=/etc/pointercal
export TSLIB_PLUGINDIR=/usr/local/lib/ts

I dont know about the "QT_QPA_GENERIC_PLUGINS" variable.
I have a problem of inverting the X axis in my QT program that run on RPI3 yet
how can I solve this?

Regards,
tictactoe

tictactoe

@SGaist
Hi
I want to install gdb on RPI as you said before.
I want to use the below link for installing gdb on rpi and ubuntu. Is it correct ?

link text

Regards

SGaist

Does look good yes

tictactoe

I dont know how to debug my qt program with gdb. Can you give me link for this?

SGaist

It's the same as any other program. Note that you can remote debug from Qt Creator. It's explained in the Launching the Debugger chapter of Qt Creator's documentation.