How can I setup beaglebone black or sabre sd for first time development?
-
http://doc.qt.io/QtForDeviceCreation/qtee-preparing-hardware-beaglebone.html
I am following these steps for qt-embedded development. I wrote qt-image to sd via flash boot to qt for both beaglebone and sabre sd but they can't open the sd card image. Is there any addinational steps to do?
-
http://doc.qt.io/QtForDeviceCreation/qtee-preparing-hardware-beaglebone.html
I am following these steps for qt-embedded development. I wrote qt-image to sd via flash boot to qt for both beaglebone and sabre sd but they can't open the sd card image. Is there any addinational steps to do?
@bcan said:
I wrote qt-image to sd via flash boot to qt for both beaglebone and sabre sd but they can't open the sd card image.
what is the error, etc.?
--- SUPPORT REQUESTS VIA CHAT WILL BE IGNORED ---
If you have a question please use the forum so others can benefit from the solution in the future -
@bcan said:
I wrote qt-image to sd via flash boot to qt for both beaglebone and sabre sd but they can't open the sd card image.
what is the error, etc.?
-
@raven-worx there is no error. When i insert sd to both boards and restart them nothing happens. They don't open any terminal/screen etc.
@bcan
i am not a Linux guru.But i would first make sure if the created SD card is actually bootable. There should be a tool available to check this i think.
--- SUPPORT REQUESTS VIA CHAT WILL BE IGNORED ---
If you have a question please use the forum so others can benefit from the solution in the future -
@bcan
i am not a Linux guru.But i would first make sure if the created SD card is actually bootable. There should be a tool available to check this i think.
@raven-worx I didn't find the tool but tried every format to make it bootable. Result didn't change.
