Unable to run the project in debug mode
-
@jsulm I'm adding the screenshots for the above tabs
And the debugger selected in the kit configuration is
-
@febinzcs
I would start by tryinggdb /path/to/your/executablein a Command Prompt outside of Qt Creator till you get that working, with whatever path togdb. -
@JonB I'm able to open gdb from C:\Qt\Tools\mingw1120_64\bin>gdb in the command prompt and saw multiple options like adding the breakpoint. Should I provide the particular path inside the creator to configure the debugger.
-
@febinzcs
If you are able to gdb the executable in question then you should be able to do so from Qt Creator. Is that using the same gdb executable/set it to do so.@JonB I've installed the gdb 13.1 using pacman and set the environment variables. I can see it as auto detected in the debugger tab under kits (with the path as msys64/usr/bin).
But, the previous error is still shown. The configure button in the "Adapter start failed error" shows options for setting target and source paths. What should be given there? -
@JonB I've installed the gdb 13.1 using pacman and set the environment variables. I can see it as auto detected in the debugger tab under kits (with the path as msys64/usr/bin).
But, the previous error is still shown. The configure button in the "Adapter start failed error" shows options for setting target and source paths. What should be given there? -
@jsulm
the dropdown to select debugger is not activated, and the corresponding manage button too . -
@febinzcs
The list shows only the 6.3.2 debugger available. The others show an "exclamation mark" warning triangle. I think you can hover over that to get a tooltip? I imagine it says it cannot find it...?
