how to debug the code on human readable code than on the assembler code in qt

[thippu]

Hi guys,
I set some breakpoints somewhere, now I want to debug the code, If I start the application in debugging mode it goes to the assembly code and executes it line by line.
I want it to execute on c++ code than assembly code.
could you help?

[mrjj]

Hi
But if the break point within your own code ?
Or do u mean to look inside Qts code ?

[thippu]

@mrjj Breakpoints are within code.

[jsulm]

@thippu Did you build your app in debug mode?

[thippu]

@jsulm Yes, buddy.

[jsulm]

@thippu On which OS are you? What compiler and debugger do you use?

[thippu]

@jsulm Windows server 12

[jsulm]

@thippu Compiler/Debugger?

[thippu]

@jsulm MinGW and debugger is also the same.

[jsulm]

@thippu This is strange. You are 100% sure your app is built in debug mode?

[thippu]

@jsulm I'm sure.

[jsulm]

@thippu Can you go to your Kit, open the Debugger tab and check whether you have any exclamation marks?

[thippu]

@jsulm Yes, I do have them. there are 2

[jsulm]

@thippu You mean two exclamation marks? What do you see if you put the mouse over the exclamation marks?

[thippu]

yellow one shows the warnings and the red one shows the error messages.

[mrjj]

@thippu
and what does warnings and error say ?

[jsulm]

@thippu said in how to debug the code on human readable code than on the assembler code in qt:

yellow one shows the warnings and the red one shows the error messages.

Come on, don't you think that you should write what the warnings/errors are?
How can "yellow one shows the warnings and the red one shows the error messages" help to identify the problem?!