Important: Please read the Qt Code of Conduct -

[Noob Question] Cross Compiling RPI3/Stretch

  • Fair warning->I'm new to Qt. I've followed several guides on the interwebs on cross compiling Qt apps (on Ubuntu 16.04 64bit) for the RPI3/Stretch without much success. So far, the closest I've gotten is with the instructions using QTRPI found here:

    I'm able to compile with the cross compiler, but when I go to run on the pi I get the following msg: EGL Error : Could not create the egl surface: error = 0x300b


    I'm guessing one of or all of my plugins isn't correct. Can anyone help me to remedy that or point me in the right direction if my assumptions are wrong?

    Thanks. Sorry if this is the wrong location for this question.

Log in to reply